Laser Engraving Instructions - Glass and Crystal Blanks

Laserable Glass and Crystal Blanks

Offers a nice clean look where lasered.

Supplies needed:
- Glass or Crystal
- Desired cleaner

Laser Raster settings:
- 35 watt DPI 300 Speed 15% Power 100%
- 60 watt DPI 300 Speed 30% Power 80%

 

Laser setting for Glass Crescents

Laser Raster settings:
- 35 watt DPI 300 Speed 15% Power 75%
- 60 watt DPI 300 Speed 30% Power 80%

Note: The recommended settings above may need adjustments for best results.
Settings will vary depending on the laser engraver brand watt and model.

Lasering Glass or Crystal:
1. Place in Laser so Glass is flat and level
2. Most Glass or Crystal are reverse engraved on back side
3. Laser substrate using settings above

Clean up:
1. After Lasering clean fingerprints with glass cleaner or lighter fluid

Tips:
- Clean substrate before lasering.  Avoid cleaning lasered area as paper towel fibers may stick